Just another Piwigo gallery

Welcome to my photo gallery

Home / Tom / h150-rebuild /

IMG_5180

IMG_5180.jpg IMG_5178ThumbnailsIMG_5181IMG_5178ThumbnailsIMG_5181IMG_5178ThumbnailsIMG_5181IMG_5178ThumbnailsIMG_5181IMG_5178ThumbnailsIMG_5181IMG_5178ThumbnailsIMG_5181IMG_5178ThumbnailsIMG_5181

used a hose clamp to clamp the quarters to the output bearing. The ridges on the quarters were ever so slightly too thick to sit in the c-clip groove of the output bearing so a little bit of attention with the cut-off wheel on the die grinder made them thin enough to snap right in to the groove.

Albums
Visits
1865